This article provides instructions on how to install and configure the Elo 2D Barcode Scanner (P/N: E926356 / Honeywell N3680) on a Windows computer.
Tools & Software Needed
- Elo 2D Barcode Scanner (P/N: E926356)
- Windows Operating System (Windows 7, 8, 8.1, 10, or 11)
- Elo 2D Scanner User’s Guide
Installation Procedure
- Connect the Scanner: Plug the 2D scanner into a compatible Elo touch monitor or touch computer using the micro USB connection interface.
- Driver Installation: Windows will automatically detect the device and install native HID drivers. To verify the installation, open the Windows Device Manager and verify the device is listed under Human Interface Devices or as a POS Barcode Scanner.
-
Ready to Scan: Once the driver setup completes, the scanner's illumination light will turn on, indicating it is active and ready to read barcodes.
Note: Out of the box, the barcode reader is configured with the following default settings:
- USB Virtual COM Port (VCP) Mode
- Presentation Mode (always scanning)
- Illumination light always on
- Red aiming pattern disables between reads
- Most common barcode symbologies enabled
- Beep sound on a successful scan
-
Common Settings Modifications: To manually apply custom configurations, scan the appropriate programming barcodes from the user guide (e.g., suffixes, interface modes, or hardware behavior):
- Clear All Suffixes: Scan this programming code before configuring new terminal suffix parameters.
- Add Carriage Return (Enter): Appends an enter key after every successful read.
- Add Tab: Appends a tab space after every successful read.
- USB PC Keyboard Mode: Configures the device to emulate standard keyboard typing.
- USB HID Mode: Configures the device as a standard USB Human Interface Device.
- USB Serial Mode: Scan this code to program the scanner to emulate an RS232-based serial COM port. If using a Windows PC, you must download and install the Honeywell USB Serial Driver. This driver assigns the scanner to the next available system COM port.
- White Illumination Control: Toggle the bright white light to turn off when idle, or keep it always active (default).
- Beeper Behavior: Turn off the buzzer completely, or restore standard audio feedback beep-on-scan behavior (default).
- Restore Defaults: Scan to reset the N3680 scanner back to factory-original operational settings.
- Software-Based Configuration: To modify scanner configurations programmatically on your computer, download the utility: Honeywell EZConfig Software Setup Utility.
- Detailed Product Reference: For additional configuration guidance, advanced terminal command parameters, and troubleshooting, please refer to the Honeywell N3680 User’s Guide.
Please report any broken links by emailing elo.support@zebra.com and include a link to the knowledge article