This article explains where to find the firmware version on 3202L, 4202L, 4602L or 5502L monitors
The firmware version can be seen in the Factory menu. See below steps (also attached to this article).
To check the xx02 IDS firmware version:
1. With the monitor powered off, press and hold the Menu button, then tap the Power button “deliberately” twice (press, hold briefly, release; then repeat). Then release the Menu button.
2. Allow the system to fully come up (to complete the Windows boot in the case where an ECM is installed).
3. Press the Menu button to bring up the Factory menu. There will be an "F" in the upper left corner of the display. Pressing the Menu button will now toggle the factory menu on or off.
4. Once in the Factory menu you will see the firmware version at the bottom of the menu. Record the full line (it won’t be exactly as shown below).
Individual functions in the Factory Menu cannot be performed without a wired OSD remote connected – with a wired OSD remote you can scroll up or down and press Select to execute Reset or Exit. To completely exit Factory mode, turn the monitor off.
Please report any broken links by emailing support@elotouch.com and include a link to the knowledge article