This article explains how to disable the Elo splash screen through the Factory OSD Menu on an ET1502L Touchmonitor

Hardware/Software Needed
• Elo 1502L touch monitor connected to a computer.

Steps

1. Connect the 1502L touch monitor to a computer video source.
2. Press the Power button and confirm display operation.
3. Press the Power button again to turn off the display.
4. While holding the Select button, press the Power button to turn on the unit. This will allow for access to the Factory menu.
5. Press the Menu button. 
   
   • The letter F should appear in the upper left corner of the OSD menu.  If it doesn’t, turn off the display and repeat step 4.
     
6.  Scroll through the OSD menu using the L or R (left or right arrow) buttons to highlight the F and press Select. The Factory display/menu will appear on the screen.
7. Scroll through the selections using the L or R button to highlight ELO LOGO.
8. Use the L or R button to change the setting to Off. Press Select. 
   • Be careful not to disturb any other options.
     
9. Use the L or R button to scroll through the options and highlight Exit and press Select.
10. Cycle power by removing the monitor's power cable for 30-seconds then reconnect cable.
    • Verify that the Elo logo does not appear during the power on sequence.